Go 1.19 started reformatting code in a way that makes it more obvious
how it will be rendered on pkg.go.dev. It gets it almost right, but not
entirely. Therefore, I had to modify some of the comments so that they
are formatted correctly.
Do it all at once in preparation for Go 1.18 support.
To make this commit, I've simply modified the `fmt-check` Makefile
target to rewrite files instead of listing the differences. So this is a
fully mechanical change, it should not have introduced any errors.
There were a few issues that were causing qemu-system-arm and
qemu-system-riscv to give the wrong exit codes. They are in fact capable
of exiting with 0 or 1 signalled from the running application, but this
functionality wasn't used. This commit changes this in the following
ways:
* It fixes SemiHosting codes, which were incorrectly written in
decimal while they should have been written in hexadecimal (oops!).
* It modifies all the baremetal main functions (aka reset handlers) to
exit with `exit(0)` instead of `abort()`.
* It changes `syscall.Exit` to call `exit(code)` instead of `abort()`
on baremetal targets.
* It adds these new exit functions where necessary, implemented in a
way that signals the correct exit status if running under QEMU.
All in all, this means that `tinygo test` doesn't have to look at the
output of a test to determine the outcome. It can simply look at the
exit code.
This change adds support for the ESP32-C3, a new chip from Espressif. It
is a RISC-V core so porting was comparatively easy.
Most peripherals are shared with the (original) ESP32 chip, but with
subtle differences. Also, the SVD file I've used gives some
peripherals/registers a different name which makes sharing code harder.
Eventually, when an official SVD file for the ESP32 is released, I
expect that a lot of code can be shared between the two chips.
More information: https://www.espressif.com/en/products/socs/esp32-c3
TODO:
- stack scheduler
- interrupts
- most peripherals (SPI, I2C, PWM, etc)
