Do it all at once in preparation for Go 1.18 support.
To make this commit, I've simply modified the `fmt-check` Makefile
target to rewrite files instead of listing the differences. So this is a
fully mechanical change, it should not have introduced any errors.
This can be very useful for some purposes:
* It makes it possible to disable the UART in cases where it is not
needed or needs to be disabled to conserve power.
* It makes it possible to disable the serial output to reduce code
size, which may be important for some chips. Sometimes, a few kB can
be saved this way.
* It makes it possible to override the default, for example you might
want to use an actual UART to debug the USB-CDC implementation.
It also lowers the dependency on having machine.Serial defined, which is
often not defined when targeting a chip. Eventually, we might want to
make it possible to write `-target=nrf52` or `-target=atmega328p` for
example to target the chip itself with no board specific assumptions.
The defaults don't change. I checked this by running `make smoketest`
before and after and comparing the results.
Previously, the machine.UART0 object had two meanings:
- it was the first UART on the chip
- it was the default output for println
These two meanings conflict, and resulted in workarounds like:
- Defining UART0 to refer to the USB-CDC interface (atsamd21,
atsamd51, nrf52840), even though that clearly isn't an UART.
- Defining NRF_UART0 to avoid a conflict with UART0 (which was
redefined as a USB-CDC interface).
- Defining aliases like UART0 = UART1, which refer to the same
hardware peripheral (stm32).
This commit changes this to use a new machine.Serial object for the
default serial port. It might refer to the first or second UART
depending on the board, or even to the USB-CDC interface. Also, UART0
now really refers to the first UART on the chip, no longer to a USB-CDC
interface.
The changes in the runtime package are all just search+replace. The
changes in the machine package are a mixture of search+replace and
manual modifications.
This commit does not affect binary size, in fact it doesn't affect the
resulting binary at all.
This means that machine.UART0, machine.UART1, etc are of type
*machine.UART, not machine.UART. This makes them easier to pass around
and avoids surprises when they are passed around by value while they
should be passed around by reference.
There is a small code size impact in some cases, but it is relatively
minor.
This makes it possible to assign I2C objects (machine.I2C0,
machine.I2C1, etc.) without needing to take a pointer.
This is important especially in the future when I2C may be driven using
DMA and the machine.I2C type needs to store some state.
This commit changes the number of wait states for the stm32f103 chip to
2 instead of 4. This gets it back in line with the datasheet, but it
also has the side effect of breaking I2C. Therefore, another (seemingly
unrelated) change is needed: the i2cTimeout constant must be increased
to a higher value to adjust to the lower flash wait states - presumably
because the lower number of wait states allows the chip to run code
faster.
